DME HG48-2000 offers interchangeable housings and assemblies to simplify the design, installation, adjustment and maintenance of stack molds.
DME Company unveiled the HG48-2000, the latest addition to its Helical Gear Stack Mold Centering Device product line. DME Helical Gear Centering Devices contain a double-helical gear shaft with a left-hand thread on one end, a right-hand thread on the other and two mating nuts that fit on the corresponding threads. The device provides equal and synchronized parting line openings for two- or four-level stack molds. The HG48-2000 measures 48mm nominal outside diameter of helical gear; 2000mm standard maximum length and 800mm standard maximum parting line opening per side. Since a stack mold usually needs two or four assemblies to operate, the devices are adjustable to compensate for differences between the moving and stationary side stack heights.
www.dme.net
- More Articles like this
- Electricity rates up 2.9% on average monthly bill: OEB
- Refuelling issues corrected at Point Lepreau nuke plant
- Wind project on Sable Island a standstill 13 years later
- Cancelled gas plant cost $275 million, Ontario auditor general says
- Green Energy Act causes Ontario power prices to soar: Frasers Institute